If you smell gas nowLeave the building without using switches, flames, or phones indoors. From outside, call 911 if there is immediate danger and call your gas utility. Contact a private-side contractor only after the area is declared safe.
The short answer
An inspection should identify the CSST manufacturer, bonding point, conductor, clamps, routing, protection, and transitions. Electrical bonding work may require a qualified electrical professional depending on scope and jurisdiction.
What matters in this situation
Gas-line planning should happen before walls close or equipment arrives. Route, pipe size, access, permits, utility coordination, and final testing can all change the practical scope.
Details that help define the next step
- CSST brand and markings
- Bonding clamp location
- Conductor path and termination
- Protection at framing penetrations
These details help establish scope; they do not replace an emergency response, onsite inspection, utility decision, permit requirement, or manufacturer instruction.
How a careful service process is organized
- Start by documenting csst brand and markings and bonding clamp location.
- Confirm conductor path and termination and protection at framing penetrations before the scope is finalized.
- Have manufacturer instructions and photos of accessible routing ready for the onsite team or authority.
- Use the findings to define the appropriate gas line installation scope, required testing, and any next authority or trade.
What to have ready when requesting service
- Manufacturer instructions
- Photos of accessible routing
- Prior inspection correction
- Electrical-service information
What not to do
Do not attach a random clamp without following the listed system instructions. Keep relevant tags, notices, equipment information, and safely obtained photos available for the people handling this specific situation.